Sentence examples for for low constraint from inspiring English sources

This appears to be sufficient in predicting lower shelf toughness under high constraint conditions, but may fail when attempting to predict toughness in the transition region or for low constraint conditions when using the same parameters.

Further, the model predicts the fracture toughness in a large part of the transition region and accurately predicts the measured shift with irradiation, although further works is required to improve the model's predictions at higher levels of fracture toughness and for low constraint conditions, which are expected to be achieved by a better accounting for plasticity.

R-curve testings of Grade X65 pipeline steel girth weld for low-constraint specimens were investigated experimentally.

Suitability of the low constraint laboratory specimens for fracture toughness measurements is also confirmed.

1 - very high constraint to 5 - very low constraint.

Evolutionarily novel splice variants may constitute an important source for evolution of novel functions because they might be under relatively low constraints [ 64]; for example, species-specific splice variants are positively correlated with non-synonymous substitution rate [ 65] and minor alternative exons evolve faster than obligate exons [ 66, 67].

A main effect of constraint level was also found, F 1, 174) = 8.3, p <.01, partial η =.045, with longer RTs for the high-constraint than for the low-constraint condition.

Instead, this correlation may have important biological implications, since it supports a model for the origin of novel genes that implies low constraints in the early stages after the duplication and an increase of constraints with time.

SNP density differs drastically across structural regions of the miRNAs, indicating strongest selective constraint for the mature and star miRNA regions and lowest constraint for sites located in loops (fig. 1 B).

This is not surprising considering the economic constraints for low cost ingredients and low cost processing.

The comparison between experimental and predicted R-curves shows that T-stress can be effectively used to obtain constraint-modified R-curves of this type of steel, that could be used for toughness prediction under low-constraint conditions.