Sentence examples for for load case from inspiring English sources

The non-linear buckled shape for both load cases is shown in Fig. 13 for Load Case IA and Fig. 14 for Load Case IB.

Open image in new window Fig. 13 Displacement contour plot for Load Case IA perpendicular thrust load Open image in new window Fig. 14 Displacement contour plot for Load Case IB diagonal thrust load.

For Load Case IB, the design load is well within the linear part of the graph; however, for Load Case IA it is located in a region where the stiffness begins to decrease slightly.

Open image in new window Fig. 18 Contour plot for the von mises stress for Load Case IA.

Figure 18 shows the contour plot for the von Mises stress for Load Case IA and a zoomed part of the angle member.

Open image in new window Fig. 15 Rotational displacement contour plot for Load Case IIA perpendicular moment load Open image in new window Fig. 16 Rotational displacement contour plot for Load Case IIB diagonal moment load Open image in new window Fig. 17 Gyroscopic moment load vs. rotation for non-linear models.

For an isotropic plate the degree of localization is found to increase with the increase in the aspect ratio for load cases (i)–(iii) but is found to be moderate for load cases (iv) and (v).

It is shown that the model accurately predicts the response of the material for load cases in which shear stresses dominate.

Further, the use of a flexible, rotating wheelset model is recommended for load cases leading to large magnitude contact force components in the high-frequency range (above 1.5 kHz).

For these load cases, M1/M2 ratio was equal to −0.5 for load cases 1 and 2 (fix-ended) and zero for load cases 3 and 4 (pin-ended).

However, in almost all cases, lower one-percentile strength ratios were produced for load cases 5 6 than for load cases 1 4.