Sentence examples for for drift correction from inspiring English sources
These results also show that our algorithm achieves better performance than the inverse compositional algorithm for drift correction.
Digital movies were constructed using an automated MATLAB routine (developed in Version 7.11.1.866 (R2010b) service pack 1) for drift correction in x, y and z dimension, respectively, and Fiji (ImageJ 1.51 g) (National Institute of Health, USA).
The Nd parameter gives the number of points used in the running average and the order parameter identifies the order of the polynomial to be fitted for drift correction.
The images were used afterwards for drift correction during PALM reconstruction.
Fixed (labeled or unlabeled) COS-7 cells or neurons were imaged in PBS, after attaching multicolored 0.1 µm beads (TetraSpeck microspheres, Invitrogen) to the coverslips for drift correction (∼4×107 beads in 20 µl PBS for 15 s, rinsed with PBS).
It is noted that in each cycle, the indenter was hold for 30 s at 10% of its previous maximum load for thermal drift correction and for assuring that complete unloading was achieved.
Water samples were then diluted 1 10 in a solution spiked with Ge for internal drift correction and analyzed for As by high-resolution inductively-coupled plasma mass spectrometry (HR ICP-MS), which eliminates the isobaric interference with ArCl.
Samples were diluted 1 10 in a solution spiked with 73Ge and 74Ge for internal drift correction and analyzed for As by high-resolution inductively coupled plasma mass spectrometry (Cheng et al. 2004; van Geen et al. 2005).
The cyclic nanoindentation tests were performed in a way with loading to the maximum load and unloading by 90%; reloading to the maximum load and unloading by 9%; holding for 10 s at 10% of the maximum load for thermal drift correction and complete unloading, as illustrated in Fig. 1.
The built-in temperature sensor allows for baseline drift correction typically encountered in conductivity/capacitance measurements without thermostating device.
Subsequently, the samples were unloaded to 10% of the maximum load and held at the same constant load for thermal drift correction.
