But it may be objectively assessed to what degree a certain reduction in concentration may be valid for a given flow-through chamber by making the CR Fl plot as explained above.
These resistances define what the pressure differences between adjacent chambers are for a given flow rate and physically describe how difficult it is to push blood through certain parts of the CVS.
The upstream pressure needed for a given flow is dependent upon the upstream resistance.
Moreover DXFP is a multipath routing protocol as it maintains multiple paths for the same source-destination flow and chooses to forward the packets of the given flow through the path of minimal cost.
The method through which the closure member regulates the flow and the configuration of the flow path through the valve impart a certain flow characteristic to the valve, which is taken into account when selecting a valve for a given flow-regulating duty.
In one version, the time taken for a given volume of fluid to flow through an opening is recorded.
For a given set of airway dimensions, turbulent flow results in a higher resistance than laminar flow.
This requires experimental evaluation for a given material at the sensor location, to capture the flow dynamics of the particulate stream through the sensor.
Each cycle consisted of three phases: (I) a linear increasing ramp from 20 to 50 V, at a rate of 0.5 V/s, (II) an interval at 50 V for certain time duration to flow a given charge Q0 through the system, and (III) a subsequent linear decreasing ramp from 50 to 20 V at 0.1 V/s.
Thus, we have T OPT f = T OPT for a given G and any flow assignment through G. Essentially, the operation of Algorithm 2 is equivalent to running Algorithm 1 on the extended conflict graph, F G ′.
Each data line thus represents percentage of the total heat flow released through hydrothermal systems at a given value of Hadean heat flow.
