Sentence examples for footprint lengths from inspiring English sources

The distribution of footprint lengths was modeled based on an empirical distribution (Fig. 2A) of footprint lengths obtained from the experimental data.

To model SD site-dependent extension of footprint lengths, footprints were generated under a similar model with two alterations.

Distributions of footprint lengths (Fig. 2) were obtained for the 2122 genes of E. coli and 1468 in B. subtil is that had an average density >10 footprints per codon.

First, to distribute the pause over three adjacent codons, the probability of P-site codon locations were set at P x = P x + 3 = P x + 6 = 3 P. Second, to model asymmetric extension, footprint lengths were extended at their 5′-end for P-site codon locations at x + 1 to x + 6 by the distance between the P-site and x. 'The caterpillar model' of SD-mediated footprint elongation is shown in Figure 1B.

The morphological features that were extracted from each of the footprint impressions are footprint length, footprint breadth, angle of walking, approximated heel radius etc.

Due to the higher gradients reached by such structures, a higher energy beam can be obtained within the same accelerator footprint length.

The components that survive produce a debris casualty area of 22 m2, a surviving mass of 532 kg, a casualty risk of 1 2800, and a debris footprint length of nearly 800 km.

The SAR altimeter offers the following benefits with respect to conventional satellite altimetry: factor of 20 improvements in the along-track resolution, the along-track footprint length which does not vary with wave height (sea state), and improved precision in sea surface height measurements or sea surface slope measurements.

PFI was calculated using the following formula: PFI = 174.9* EPL−NPL /NPL+80.3* ETS−NTS /NTS−13.4; where EPL and ETS are footprint length and width, respectively, measured 1, 2, 4, 7 or 11 days after injury; and NPL and NTS are footprint length and width, respectively, measured before injury [17].

Footprint length can be used to estimate a hip height of 1.4 m and a body length of approximately 6 7 m [19], [22], which is close to the size of the coeval southern African theropod Dracovenator regenti [23].

It is clear that irrespective of the footprint length, 5′-end locations remain unchanged.