Sentence examples for follows loading from inspiring English sources

The loading percentage of DOX in CNTs was calculated as follows: Loading percentage  = (initial weight of DOX−residual weight of DOX /weight of DOX-loaded CNTs × 100%%.

The experimental parameters are set as follows: loading frequency f = 15 Hz; stress ratio R = 0.06; maximum stress σ max = 200 Mpa.

The results show that the influent parameters on the KIc can be ranked from the most important to the least one as follows: loading rate, temperature and RA content.

The appropriate parameters were as follows: loading frequency 3 5 Hz, notch tip radius r = (0.2 0.3) mm, opening angle α = 60°, and notch depth t = (0.14 0.17 D.

Drug loading efficiency and drug loading capacity (Table 2) were calculated as follows: Loading capacity % = A - B / C × 100 Loading efficiency % = A - B / A × 100, where A is the total weight of naproxen used, B is the weight of unloaded naproxen in the precipitate after centrifugation and C is the weight of copolymer.

To rule out the possibility that the observed higher walking speeds at the initial phase (Fig. 4) resulted from the smaller loads carried as compared to the established phase (Fig. 3), load mass was standardized regarding the size of the ant that carry it, as follows: Loading Ratio = [Load mass+Ant mass]/Ant mass [28].

Results obtained from the experimental research are as follows: Load capacity of strengthened test specimens has increased compared to the load capacity of the shear deficient reference specimen DE2.

A number of the effective parameters on the drilling rate are as follows: load on bit, rotation, depth, rock strength, bit condition, formation pressure, mud weight, mud type, bit diameter, and mud flow rate (Bourgoyne and Young 1974).

The algorithm is as follows: Load the input sequences as 2-bit codes.

The load independent- and load dependent EEG analysis was performed as follows: Load independent analysis: EEG power during the retention period: Load dependent analysis: The power in trials with ss5 was compared to trials with ss2 ('ss5–ss2') for each frequency point.

Following loading, minimal dexPˉ release was observed in the absence of an electrical stimulus, while dexPˉ release was triggered upon application of a suitable electrical stimulus.