Sentence examples for flush mode from inspiring English sources

The valve position was then switched to allow the bound material to be eluted from the extraction cartridge in back flush mode directly onto the analytical column with 0.1% formic acid-methanol (95:5 v/v) at a flow rate of 200 μl min-1.

The valve position was then switched to allow the bound material to be eluted from the extraction cartridge in back flush mode directly onto the analytical column (Betabasic 18, 100 × 2.1 mm, 3.0 μm particle size, Thermo Fisher Scientific, USA) coupled with a guard column using the same packing material (10 × 2.1 mm/3.0 μm, Thermo Fisher Scientific, USA).

After loading, peptides were eluted in back flush mode onto the analytical nano-column (Magic C18, 5 mm, 100 Å, 0.075 mm i.d. × 75 mm length) using an acetonitrile gradient of 5%to40%0% solvent B (0.1% formic acid in water/acetonitrile 4.9 95) in 60 min at a flow rate of ~400 nl/min.

At this position, the MII could pass through the ODS column, where the fluorescent product was eluted in a back-flush mode to the detector.

Such comparison was carried out to determine which air flushing mode will consumed lower energy.

In this section a comparison study was carried out between pulsed and continuous air flushing mode conducted for remediation of soil contaminated with lubricant oil.

Therefore, the pulsed air flushing mode was applied with coarse soil contaminated with 25 and 50 wt% waste lubricant oils in presence of 3 wt% nonionic surfactant.

The results found in Tables 2 and 3 shows that both air flushing modes are succeeded to remove the same percentage from pollutant (93 wt%) at different time 600 and 40 s for continuous and pulsed air flushing, respectively, this means the performance of using the pulsed air flushing mode over the continuous mode for soil remediation.

Dissolved samples were injected on an Ultimate gradient LC-System (LC Packings) equipped with pre-columns (25×0.075 mm packed in-house, C18, 5 µm, 300A (Vydac, Hesperia, USA)) working in back-flush mode.

Online SPE-LC was performed in back-flush mode utilizing a setup similar to that recently described [ 27].

Thereafter, the six-port valve was switched and the analytes were eluted in back-flush mode from the SPE column by the more hydrophobic flow (57% ACN) delivered by pump 2 (Electronic Supplementary Material Fig.  S1).