Sentence examples for fluid mounting from inspiring English sources
The supporting mode of frame particle is changed from dot line contact to fluid mounting, and the connectivity of pore throat network becomes better.
Dissected inflorescences were dried in a LADD model 28000 critical point dryer using CO2 as a transitional fluid, mounted on metal stubs, and grounded with conductive silver paint.
The negative control used in this study was depleted cell culture fluid mounted to HepG2 cell for the same time as the virus was grown in those cells; the supernatant was cleared by centrifugation in order to get rid of cellular debris – the same was done with the virus stocks – but still may contain soluble proteins that may have an immunomodulatory effect.
Therefore, an automatic optimal technique is needed to optimize the fluid mount.
Chen et al. [19] researched the dynamic model and experimental testing of magnetorheological fluid mounts, especially at a wide frequency.
In this paper, the new fluid mount design concept and its mathematical model and simulation results will be presented.
When designing fluid mounts, design parameters can be varied in order to obtain a desired notch frequency and notch depth.
Passive fluid mounts are widely used in the automotive and aerospace applications to isolate the cabin from the engine noise and vibration.
Since current passive fluid mount designs have only one notch, isolation is only possible at N1 or at N2, but not both.
In the case of aerospace fixed wing applications, when fluid mounts are used, they are placed in between the engine and the fuselage, and the notch frequency of each fluid mount is tuned to either N1 frequency (engine low speed shaft imbalance excitation frequency) or to N2 frequency (engine high speed shaft imbalance excitation frequency) at the cruise condition.
Here, in this paper, a double-notch passive fluid mount design will be presented, which has two notch frequencies, and therefore can provide vibration and noise isolation at two frequencies.
