Sentence examples for fluctuation under the from inspiring English sources

With FKBP12 as the model target protein, the ligand binding pocket-oriented labeling reagent could label intracellular protein, whereas protein surface-oriented reagent was ineffective for labeling in living cells, partially because of the intracellular protein fluctuation under the macromolecular crowding effects.

Surface fatigue is a phenomenon caused as a result of the effects of stress fluctuations under the condition which two solid materials have sliding contact [38].

The model seeks to maximize power generation and minimize output fluctuations under the constraints of multilayer architecture of the power network and balanced allocation of power curtailment.

This target has been designed to have minimal target density fluctuations under the heat load of a 20μA CW 854.3 MeV electron beam without rastering the electron beam.

Initial coating efforts reveal that pigment and adsorbed dispersant, with extra negative charges, dramatically raise positive current and cause power fluctuations under the constant-voltage mode.

Following Hamilton (1988), some versions of the hidden Markov models have been extensively used in macroeconometrics to model business cycle fluctuations under the name of Markov Switching regression models.

It was also found that the two-environment PDF approach reproduces the sensitivity of the CO and CO2 peak levels versus the O2 concentration variation, as well as the peak levels of NO conditional fluctuations under the MILD combustion condition.

Korobkova et al. found that the tumbling frequency exhibited large and relatively slow temporal fluctuations under the no chemoattractant condition and the time duration of counterclockwise rotation of the flagellar motor showed a heavy-tailed distribution away from exponential distribution [18].

Different from the continuous wind power fluctuation under normal weather condition, the power output of individual wind turbine drops suddenly under extreme weather.

Since the initial plastic deformation is achieved by dislocation nucleation and motion for both the aluminum and copper, the critical forces for dislocation nucleation are lower at higher temperature, as thermal fluctuation under high temperature assists the cutting tool-induced metallic bonds breaking.

However, ultimate recovery increases with smaller fluctuation under segmentation and restructuring, and the vertical sweep efficiency increases gradually.