The number of flowers removed was recorded and each stem used for a cross was marked with colored thread for tracking purposes.
Briefly, the inflorescences with open flowers removed was fixed in 4% glutaraldehyde (in 12.5 mM cacodylate, pH 6.9), and vacuumed until the tissues were all sunk in the bottom of the container.
Reproductive output was monitored by counting the number of closed flowers removed every 2 3 days (before they opened) from the beginning of flowering, and by counting numbers of closed flowers and buds 2 mm or larger at the end of infestation M1 in 2010, and during all infestations in 2011.
To establish the status of the stem transcriptome prior to the period at which the maximal elongation rate has been achieved, gene expression profiling was conducted on the top 1 cm segment of the stem (with flowers removed), and this YNG transcript profile was then compared to the profile generated from segments representing the GKP-identified maximum growth rate (MGR) phase.
Once the plant has it's flowers removed, place the container in full sun and fertilize according to package directions.
Once plants are flowering, remove excess male plants.
If these are obvious (usually in larger flowers), remove them.
If you do take a cutting from an herb that is flowering, remove the flowers from the cutting before propagating.
When you're ready to press the flowers, remove the top piece of the flower press and set it aside with the wingnuts.
Thread three beads (in any color combination you like) onto the double layer of string, then take one of the money flowers, remove the binder clips and pass the strings through the center.
To ensure uniformity in the stage of flower development, all open flowers were removed in the afternoon preceding crosses.
