It is shown that, according to the importance, these factors can be listed, from high to low, as the follows: mixture pressure, cooling air velocity and its temperature, cooling water line flow rate and gap width of air channel, and wall inclined angle.
The effects of number of channels, inlet mass flow rate, flow direction and width of channels on the thermal behaviors of the battery pack were analyzed.
Namely, the rate and width of the network bursts were found to increase with cluster size.
Design and operation parameters such as flow rate, detector temperature, and width of the micro-fluidic channel were investigated.
The fluid shear stress generated on the cells by flow was estimated to be 2 to 20 dyn/cm2 by using the formula τ = 6 μ Q/wh, where μ is the dynamic viscosity of the perfusate, Q is the flow rate, and h and w are the channel height and width, respectively.
However, kerf width increases with the increase of flow rate and servo voltage.
The quality of theoretical fractionation, which we quantify by resolution, improves strongly with reduced collector width, reduced volume flow rate and increased voltage input.
It is found that the total solidification length (metallurgical length) in a continuous casting process is proportional to the mass flow rate and specific heat capacity and inversely proportional to the conductivity and width to thickness ratio of the slab.
Width distribution along the draw direction was measured on a iPP resin supplied by Montell as function of both flow rate and take up velocity.
Fig. 7 Relationship between kerf width and wire tension, wire running speed, flow rate and servo voltage.
