Sentence examples for flexure between from inspiring English sources

Their joint gravity and GPS observations thoroughly cover the sites of lithospheric flexure between the Sichuan Basin and the Eastern Tibetan Plateau.

Although dorsal flexure between tergites was limited by the backward projecting keels, specimens show that the animal could also curve to a large degree in this direction (either actively or passively) without disarticulating.

However, such a dichotomous or trichotomous division of the large bowel was challenged by results of a recent study, demonstrating that differential clinicopathological or molecular features between proximal and distal CRCs do not change abruptly at the splenic flexure or between the sigmoid and the rectosigmoid, but show gradual change along the large bowel (Yamauchi et al, 2012a, 2012b).

On ship, especially on large ship, the flexure deformation between Master (M /Slave (S) Inertial Navigation System (INS) is a key factor which determines the accuracy of the integrated system of M/S INS.

The technique to extrude the glans consisted of grasping the sigmoid flexure firmly between the index finger and the thumb, pushing upwards towards the prepuce orifice and, at the same time, pushing the prepuce downwards [ 8].

Sakai and Gajurel (2012) identified a buried flexure around Mulpani (between Locs.

Also, the coupling between flexure problem and associated torsion problem is eliminated through an iterative method (Vijayakumar 2011a).

However, the behavior of hollow reinforced concrete and prestressed concrete bridge columns is complicated because of the interaction between flexure and shear, and the reversed cyclic loads.

The performance and failure mode of all panels tested revealed strong coupling between flexure and shear due to the squat-type geometry of the panels.

The interaction between flexure and shear was introduced by a panel element's biaxial behavior in a modified fiber element formulation.

In routine design, non-uniform (warping) torsion influence is sometimes neglected in structural analysis: internal forces and bending moments are hence incorrect and the coupling between flexure and torsion is never considered also in buckling analysis.