Sentence examples for fixed deposition from inspiring English sources

Au droplets are fabricated with a fixed deposition amount of 2 nm and a fixed annealing duration of 30 s at each annealing temperature.

Even under fixed deposition conditions, the morphologies of nanohelices varied with the metal used.

We focus on the effect of the choice of metal element (at fixed contents of the non-metal elements and fixed deposition parameters) on material structure and properties.

Second, temperature has been varied from 500 to 800°C, at constant HCl and silane partial pressures (respectively, 160 and 100 mTorr) and fixed deposition time (results not shown).

In general, the Au nanostructures including the Au piles, nano-mounds, islands, and the self-assembled round dome-shaped Au NPs were successfully fabricated on sapphire by varying the AT with the fixed deposition amount (DA) and DT, as shown in Fig. 1b, c.

These values are consistent with nighttime deposition velocities reported in the literature (Table 2) and overlap with the range of fixed deposition velocities of 0.1 0.4 cms−1 used in global methanol budgets (Singh et al., 2000; Galbally and Kirstine, 2002; Heikes et al., 2002; von Kuhlmann et al., 2003a, b; Jacob et al., 2005; Millet et al., 2008).

After deposition of 2-nm Au, the annealing temperature is systematically varied from 50°C to 850°C with a fixed Au deposition amount of 2 nm and a fixed annealing duration of 30 s.

The results show that at the same cathodic peak current density, pulse period and a fixed electro-deposition time or electro-deposition thickness, the surface roughness can be reduced by as much as 2 3 times when a ramp-down spike was used in the cases of triangular, rectangular and ramp-down waveforms.

Figure 3a shows the mass spectrum of copper nanoparticles deposited on Si substrates under 10, 30, 50, 70, and 90 sccm Ar flow rates where deposition times were fixed for all deposition processes.

The thickness of Ag layers was in range of 20 80 nm by fixing the deposition rate at 2 nm/s and variation of deposition time between 10 and 40 s.

Linear depositions were not observed (i) when motile cells were fixed directly after deposition, (ii) with non-motile cells, and (iii) with A− cells (A−S+ strain), strongly suggesting that these depositions are specifically associated with the A-motility.