Sentence examples for fire test for from inspiring English sources

Consideration of this problem also highlights areas where relying on the standard fire test for structural fire design may lead to unconservative designs.

The move from using the standard fire test for structural fire design towards more rational design methods has led to an increased requirement for numerical modelling of structures in fire conditions.

Open image in new window Fig. 6 Photographs of specimens after fire test for 2 h. a W15 (left exposed surface, right unexposed surface).

Four fire tests for Joint-A and two for Joint-B were investigated with applied moment varying between 30%70%% of the joint capacity.

To improve the fire resistance of the confined concrete cylinders, a fireproof additive was also applied to three other groups of specimens (Groups 5, 6, and 7) and these specimens were also fire tested for 4 min, 8 min, and 12 min, respectively.

This paper presents the results and observations from those fire tests for three floor systems: (i) solid timber floor joists, (ii) I-section floor beams with solid timber top and bottom flanges and an oriented strand board (OSB) web, and (iii) a timber truss incorporating solid timber upper and lower chord members and a pressed steel web member.

Of the layout models, room was selected for fire test of a single compartment.

The results show good agreement between experimental and numerical predictions and allow concluding that for a fire test of 1.6 MW of average heat release power, the exhaust and ventilation system is not enough to extract the hot combustion products.

This paper has provided very useful fire test data for use in the fire design of non-load bearing LSF walls, which can also be used in developing advanced thermal finite element models and their calibration.

Congress mandated honest live-fire tests for the vehicle under the supervision of the National Academy of Sciences.

In providing an answer, fire test results are presented for 13 different steel members protected by different DFTs of a selected intumescent coating.