Sentence examples for finite changes in from inspiring English sources

The constitutive model takes into account the evolution of the size, shape, orientation, and distribution of the underlying pores in the material, resulting from the finite changes in geometry that are induced by the applied loading.

The solid lines plotted in the Figure correspond to the parameter estimates listed in Table 2. To estimate the sensitivity of the model prediction to finite changes in parameter values, the sensitivity was computed as the relative change in mean squared error due to a 10% change in a given parameter value.

It is based on the assumption that at each training iteration the distribution of cells is changed by infinitely small amount, correspondingly requiring an infinite number of training iterations to achieve finite changes in cell distribution.

An oversimplifying pin-joint approximation cannot capture the finite change in the knee forces due to the singularity effect.

The probability calculation results suggest changing multiple flow patterns with one or two dominant flow for each of the seven sets of experimental conveying conditions and that a finite change in the dominant flow pattern would occur with an increasing superficial gas velocity.

However, MCA approaches focus on the effects of individual infinitesimal changes in enzyme activity rather than the compound effects of multiple finite changes and FBA, in its standard form, does not relate flux changes to substrate concentration changes.

We illustrate the method with several numerical experiments, some developing pinch-off and topological changes in finite time.

The association of object-oriented programming and symbolic computation techniques introduces certain changes in finite element code organization.

The former makes and breaks the connection between the crankshaft and the transmission, while the latter changes, in finite steps, the ratio between the input and output speeds and torques of the transmission.

Using the finite volume method, the changes in complex fluid velocity in the stator and rotor zones at different times were determined.

It is shown that by careful cantilever design and finite element modelling that changes in yield stress after implantation can be measured even with the influence of a strong size effect.