Sentence examples for final cross section from inspiring English sources

Corrosion-dominated region is A, where corrosive degradation is too rapid in induced EIC at the applied mechanical stress, leading to final mechanical failure of the specimen, and final cross section is too small to avoid the mechanical failure whereas no corrosion-dominated region occurs in Cl− ion concentration dependence.

Tensile strength of the rods rolled to the compression ratio 5.4 6.6 with final cross-section of 10 12 mm approached 200 MPa for both polymers.

Combining the results of the l upsilon q (q) over bar and q (q) over barq (q) over bar final states, cross section and mass exclusion limits are set for models that predict heavy spin-1 and spin-2 resonances.

The final output beam cross section at the second stage of beam shaping is a square with a dimension of about 5 by 5 mm.

Based on the inverse results of profiles (Abar {A}), (Bbar {B}), and (Cbar {C}) presented in Figure 29, a final interpretive geologic cross section of a conductive sheet of (h=50 m, a=7,500 m, θ=142°) is suggested for the three anomalous SP closures located at the northern side of the Grossensees site.

This window becomes progressively smaller and more like the desired shape, pass after pass, until at the end, in the final pass, the specified cross section is obtained.

Figure 11 shows the final conceptual model for the cross section AB of Fig. 1b.

Trees thinned from plot buffer zones at age 38 were selected to represent a final harvest cross-section of each treatment for evaluation of bole form, component biomass, and crown architecture.

Afterward, it was time for the tears, time to receive a final trophy, in the form of a cross section of a clay court.

The determination of cross section uncertainty propagation on evaluated final parameter was implemented into these codes.

Abstract: A measurement of the triple-differential cross section,, in photon + jets final states using a data sample from proton-proton collisions at = 7 TeV is presented.