Gunlycke, D. & White, C. T. Graphene valley filter using a line defect.
However, this did not prove to be any better than a simple passive filter using a 2K resistor and a 1.1uF capacitance.
The design of a robust controller and fault detection filter using a µ synthesis methodology is studied.
The design of a wideband (10kHz-100kHz) bandpass filter using a single LTC1064 plus an LTC1064-4 is described.
We investigated power handling capability of a high-temperature superconducting transmit filter using a stripline (SL) structure.
For muscle activation, the raw sEMG signals were A/D converted (16 bit), full wave rectified and low pass filtered with a second order single pass Butterworth filter, using a cut-off frequency of 2.5 Hz.
J. Chang, M. P. Fok, J. Meister, and P. R. Prucnal, "A single source microwave photonic filter using a novel single-mode fiber to multimode fiber coupling technique", Optics Express, vol. 21, no. 5, pp. 5585 5593, Jan . 2013
J. Chang, Y. Deng, M. P. Fok, J. Meister, and P. R. Prucnal, "A photonic microwave FIR filter using a spectrally sliced supercontinuum source," Applied Optics, vol. 51, no.
A novel N-path filter using a complex impedance is designed to replace the frontend SAW filters in receivers with on-chip bandpass filters.
We designed and tested a Wiener filter using a set of 20 sensor-glucose tracings (∼30 h each) with a 1-min sample interval.
These results mean that an SL filter using a Dy Ba Cu O bulk resonator may be practicable as a high-power transmit BPF.
