For hardware components, a difficulty is to extract significant high-level criteria to characterize the power features of the hardware configuration (iv).
The optimized total volume, aspect ratios of the units, the number of tubes through the length and width, the heat transfer area of the HRSG and thermodynamic properties are significant features of the flow configuration resulted from constructal design.
In this study, the air circulation rate, the rate of water production, the tube diameters and the number of condenser tubes are significant features of the flow configuration inducted by the constructal design.
This geometrical simplification is achieved through a fully automatic shape optimization procedure, taking into account that key mechanical features of the original configuration are to be kept in the simplified design.
However, the prime feature of this configuration is the dazzling 13″ QHD + IGZO touchscreen, which is set at a 3200 x 1800 resolution.
Features of these configurations encounter new challenges in order to expand from being a network of computers to a network of both computers and things.
Key feature of this configuration is the contact points (or small contact-regions) of nodes with bounding membranes, instead of filament-membrane contact lines characterizing the conventional unwoven-filament geometries; undesirable contact lines create "dead-flow" zones, that promote reduced mass-transfer (i.e. increased concentration polarization-CP) and fouling.
The predominate feature of the lithiated configuration is the presence of several Li involved tetrahedrons with the formation of LiC/LiO bonds.
A key feature of the FJ configuration is that when the central tube is slightly recessed, the fuel partially premixes with air from the annulus inducing inhomogeneity, the extent of which depends on the recession distance.
A relatively new idea in tectono-sedimentology that has been successful in hydrocarbon exploration is to analyze response relationships between syndepositional faulting and sequence stratigraphic patterns, sedimentary infill features, and the configuration of source, reservoir and seal (Gawthorpe and Leeder 2000; Devault and Jeremiah 2002; Lin et al. 2005; Liao et al. 2012).
