Within the blocks, the ore deposits tend to occur in nearly vertical mineralized faults or fault zones in the rhyolite.
Several hydraulic test data indicated the influence of faults or fault zones acting as distant hydraulic boundaries.
Early fault identification systems enable detecting and diagnosing early onset faults or fault causes which allow maintenance planning on the equipment showing signs of deterioration or failure.
Four third-order sequences controlled by syndepositional faults or fault slope break zones were identified, based on the characteristics of sequence boundaries and sedimentary successions.
Only the lowstand systems tracts developed, consisting of lowstand deltas deposited on the landward side of the syndepositional faults or fault slope break zones, and lowstand fans or sublacustrine fans deposited on the lakeward side of the zones.
The simulation calculation shows that this principle can correctly identify the fault line in the conditions of the high resistance grounding, weak feedback, faults on two-phase operation of the line, evolved faults or fault during oscillation, and is not affected by power flow transferring.
Lowstand systems tracts at hinged margins consist of incised channel fills deposited on the landward side of gently dipping parallel and broom-shaped syndepositional faults or fault slope break zones and lowstand fans or sublacustrine fans deposited on the shores of lakes.
One sinister finding by investigators is that the fire seems to have started in two places and that there was a lot of combustible material lying about.No one rules out arson by someone or other, but neither is misfortune discounted, as the result, say, of an electrical fault or faults.
It is proved based on the Lyapunov stability theorem that the designed control algorithm can achieve the attitude asymptotic stability both on the fault or fault-free condition.
The results show an accurate prediction of the device electro-thermal behaviour under short-circuit conditions, with a possible optimal design of the desaturation circuit parameters when the device experiences hard-switched-fault or fault-under-load events.
