Sentence examples for fault tests from inspiring English sources

Neurological function was assessed using the Morris water maze and foot fault tests.

Whereas dynamic characteristics of the MG are investigated in cases of power change of loads or sources and motor starting, transient properties are surveyed through staged fault tests (e.g. single-phase and three-phase to ground faults) and the MG's operation transition between grid-connected and islanded modes.

The nonstationary vibration data was acquired from the gear and rolling bearing fault test-beds, respectively.

Whereas the CVs of the fault testing samples were all quite low; falling below the presupposed threshold of 0.6.

Results of a fault test performed in the unsaturated zone of Yucca Mountain, Nevada, were analyzed using a three-dimensional numerical model.

Nonlinear simulation tests are carried out using a fault test sequence applied to a two engine two propeller system.

The relevant statistic values of them are calculated as final test samples in the stage of fault testing.

An efficient design-for-testability (DFT) technique is proposed to achieve low overhead for scan-based delay fault testing.

Apparently, the MDs of the normal testing samples were quite low, while those of the fault testing samples were quite large.

Conversely, the CVs of the normal samples were relatively large, whereas the CVs of all fault testing samples were quite low, falling below the presupposed threshold of 0.6.

For the present fault test model, the use of a mesh size of 100 m, among our other simulation cases, yields the best accuracy.