Sentence examples for fault testing from inspiring English sources

An efficient design-for-testability (DFT) technique is proposed to achieve low overhead for scan-based delay fault testing.

The relevant statistic values of them are calculated as final test samples in the stage of fault testing.

Research conducted over the years has shown that the application of single input change (SIC) pairs of test patterns for sequential, i.e. stuck-open and delay fault testing is extremely efficient.

Whereas the CVs of the fault testing samples were all quite low; falling below the presupposed threshold of 0.6.

Conversely, the CVs of the normal samples were relatively large, whereas the CVs of all fault testing samples were quite low, falling below the presupposed threshold of 0.6.

Apparently, the MDs of the normal testing samples were quite low, while those of the fault testing samples were quite large.

The nonstationary vibration data was acquired from the gear and rolling bearing fault test-beds, respectively.

Neurological function was assessed using the Morris water maze and foot fault tests.

Results of a fault test performed in the unsaturated zone of Yucca Mountain, Nevada, were analyzed using a three-dimensional numerical model.

Nonlinear simulation tests are carried out using a fault test sequence applied to a two engine two propeller system.

Development of a method to implement verifiable and lightweight executable FP models enables future missions to have access to larger fault test domains and verifiable design patterns.