Sentence examples for fault stage from inspiring English sources

The initial isolated fault stage is defined by separated and small-sized half-grabens associated with short-dispersal alluvium.

As expected, the higher level of degradation (i.e., fault case 3) causes the most significant reduction in the SINR50 during the fault stage of the simulation.

Also, relative magnitudes of negative and zero sequences from pre-fault to the fault stage are used to distinguish between phase-to-phase (LL) and phase-to-phase-to-ground (LLg) faults.

According to these results, we propose a model showing the evolution of polygonal fault intervals in which faulting stages are separated by a quiescence phase during burial.

Whoever was at fault, this stage was a breakthrough for Kittel, as unlike his stage one victory in Corsica, when Cavendish had been held up by a crash, here the 25-year-old overcame both the Manxman and Greipel, overhauling the latter in the final metres to become the first rider to win two stages in this Tour.

In the fault location stage, the distance between the fault and the relay is determined.

In contrast, the rapid fault propagation stage is characterised by much longer dispersal systems of fan-delta deposits.

The advanced fault depression stage was from the Es2 period to the Dongying period, during which the fault activity weakened, and uplift occurred in the late Dongying period, and there was great erosion (Lu et al. 2007).

Hence, major drainage catchments and long-dispersal depositional systems of sand-rich deposits are facilitated during this early fault propagation stage, which may be a key aspect for the tectono-sedimentary evolution in rift basins.

The relation between the fault detection stage of the HMM-FDI scheme and the likelihood ratio test is explicitly revealed and theoretical upper bounds of the false alarm and missed detection probabilities are evaluated.

As shown in Fig. 9 and Table 2, the transient voltage and current on two ends of the positive pole line rise at fault initial stage for a fault at F2, but the transient energies detected on both ends of the line don't exceed the fixed threshold, thus the protection units at two ends will not operate.