It can be seen that the nanofibers obtained at PVP concentration of 75 and 94 g L−1 maintained good fibrous morphology (Fig. 3a, b), whereas the nanofibrous morphology fabricated at 140 g L−1 of PVP concentration was completely distorted and porous nest-like structure was formed.
To the best of our knowledge, no previous results exhibit such morphology fabricated by thermal evaporation method.
A series of samples with different Pd loadings were fabricated, while the morphology and the structural features were well examined by transmission electron microscopy (TEM), X-ray diffraction (XRD) and X-ray photoelectron spectroscopy (XPS).
Nanofibrous scaffolds of poly-l-lactide (PLLA, 860 ± 110 nm), PLLA/HA (845 ± 140 nm) and PLLA/collagen/HA (310 ± 125 nm) were fabricated, and the morphology, chemical and mechanical characterization of the nanofibers were evaluated using scanning electron microscopy, Fourier transform infrared spectroscopy and tensile testing, respectively.
Core shell and blend nanofibers of laminin incorporated poly L-lactic acid)-co-poly L-lacticacid -co-poly) with diacid -co-poly6 ± 110 nm acid -co-poly nm were respectively, fabricated and the morphology, surface hydrophilicity, chemical and mechanical properties were investigated.
Sm3+ doped TiO2 nanocrystals with various morphologies were fabricated via a facile hydrothermal route, and the effect of morphology on the luminescence properties and photocatalytic activity of the products has been investigated.
Figure 1 shows the morphology of fabricated continuous ultrathin gold nanofilms.
Figure 8 Schematic drawings of the possible effect of Cu content on the morphology of fabricated surface.
Deposition angle and substrate temperature were found to be the most important parameters for the morphology of fabricated films.
Fine powders with distinct particle size, size distribution and morphology were fabricated.
Graphene oxide (GO) supported Al2S3 with hierarchical nanorambutan like morphology was fabricated by employing hydrothermal method.
