Sentence examples for extraction holes from inspiring English sources

It provides additional resistance to the gas-liquid interface and sometimes can be used as an effective approach for liquid control, such as avoiding liquid leakage by extraction holes in immersion lithography and other microfluidic devices.

It was found that a larger number of beam lines increased the total intensity due to the increase of the angular coverage although the average intensity of each beam line decreased a bit due to a finite reflector missing caused by the beam extraction holes in the reflector.

In addition, the stability of anode spot plasma in the presence of ion beam extraction through an extraction hole is discussed in terms of the particle balance model.

Especially, a small extraction hole in the acceleration region was set for getting relative high mass resolution, an ion detector with a large rectangular effective area were designed for getting wide ion kinetic energy distribution measurement capability.

Anode spot plasmas are generated near the extraction hole of 2 mm in diameter at the center of a bias electrode whose area exposed to the ambient plasma can be changed.

This was attributed to the formation of shallow gap states in these oxides which are located just below the Fermi level and above the polymer HOMO and thus may act as a barrier-free path for the extraction of holes.

Close to a constant-pressure boundary (e.g. an extraction bore-hole), flow and contaminants can be channelled by fractures.

Furthermore, the GO exhibits selectivity in the hole extraction, which can inhibit the recombination of holes and electrons at the interface between the perovskite and PEDOT PSS.

The lower relative PL intensity of the GO-modified perovskite film suggests that the GO modification can accelerate hole extraction from the perovskite layer to the hole transport layer, which supports the enhanced performance of those PSCs formed on the GO-modified PEDOT PSS [28].

The hole-selective transport properties of the GO pieces can also improve the hole extraction and limit the recombination current from the electrons and holes [27, 30].

Standard K-nails of sizes 12 and 13 were converted to interlocking nails by drilling one hole at the proximal end (The hole was placed obliquely at 130° to the long axis of the nail and started at 2 cm below the end of the slot for extraction) and two holes at the distal end.