Sentence examples for external hot from inspiring English sources

The two executive suites are huge, featuring their own timber-decked playgrounds and external hot tubs.

Most of the efforts to improve energy system configurations are directed towards the recovery of internal heat, which reduces the contribution of the external hot source and enhance system efficiency accordingly.

In this work water enters a vertical tube as compressed liquid and leaves at low vapour quality values whereas an external hot gases stream perpendicular to the tube supplies the heat flux required to the evaporation process.

Optimising the size of the heat storage vessel as well as the initial temperature of the heat storage fluid decreased the requirement for external hot utility for an industrial case study by 33% compared to using known parameters.

The extremely low thickness of the liquid film allows for a low filling pressure, making the technology very simple without the need for any external hot reservoir and with the possibility to easily bend the tube.

The classical model on erosion combustion of energetic materials explains the phenomenon of increasing the combustion rate with growing an external hot flow speed only by heat effects caused by turbulence of the flow.

Using the Controlled Tensile Weldability (CTW) test, an external load hot cracking test, the influence of constant pre-load and different extension rates on the solidification cracking behavior of GTA (Gas Tungsten Arc) welds in an austenitic (AISI 309) and a ferritic (AISI 441) steel were investigated.

The H2 has the usual spacious NZXT internals: room for an ATX board, eight hard drives plus an external SATA hot-swap port, a 170mm heatsink, plenty of front-panel ports, and so on.

Fat may insulate the interior from very hot external temperatures, but it also may compromise heat transfer from interior to skin.

The machine performance, as described by the coefficient of performance (COP) and cooling capacity was then measured at different flow rates and temperatures of the external cool and hot water loops and for different temperatures of produced chilled water.

Two alternative operation modes are discussed, the asymmetric operation mode, where the synthesis reaction and the combustion are separated in time and the symmetric operation mode with external combustion and hot gas injection, or with air injection and in situ hydrogen combustion.