Sentence examples for exterior radius from inspiring English sources

Here we demonstrate that a hollow carbon nanofiber with proper interior to exterior radius ratio can enable Li-ions to deposit on the inner surface of the channels selectively due to the drifting effect from the structural stresses.

The dynamic equation that governs the temporal behavior of the exterior radius in the free state was defined as α (t ) : = R o (t ) R o (t 0 ), which is the ratio of free exterior radius to its initial value.

Use the mass of each component at the final time and corresponding density, the final volume was determined and Parameter R o(t = 30 mon) was calculated, which is the exterior radius in month 30 assuming the interior radius is the same as that in month 7.5, i.e. its initial value.

Since both interior and exterior radii increase, the lowest possible radius at the internal surface was R i(t = 30 mons) = R i t0).

1) The LV was modeled as a concentric spherical shell with interior and exterior radii R i and R o, respectively, at the no-load state.

Further, since the deformed wall thickness is smaller than that in the free state, volume conservation between free state and deformed state of LV wall guaranties r o > R o and r i > R i. Additionally, the ratio between deformed and free exterior radii λ (t ) : = r o (t ) R o (t ) is always larger than 1 (λ(t) > 1) since r o > R o.

To satisfy safety regulations of Economic Commission for Europe (ECE), the surface regions of automobile parts must have a sufficient degree of roundness if there is any chance that they could contact a sphere of 50.0 mm radius (exterior parts) or 82.5 mm radius (interior parts).

The potential T at a point P can be expressed in terms of anomalies Δ g(Q) at points Q on an exterior boundary σas 1where R is the reference radius of the surface (1738 km in our case) and the kernel S P, Q) is the Stokes-Pizetti kernel [ Heiskanen and Moritz, 1984].

Then the found exterior and interior hulls are transformed to spherical surfaces of radii R + D/2 and R − D/2 correspondingly, where the sphere radius R is estimated as the median of distances from the data points to the sphere center, which was estimated on Section 3.1, and the layer depth D is estimated as the median distance between the hulls.

[ 12] A web, e.g., a spider web, has an exterior edge or frame, and an interior, consisting of radii and connecting points.

In this video, 64 lasers rotating and shooting in a 360 degree radius 900 times per minute produced all the exterior scenes.