Sentence examples for extent and width from inspiring English sources

There are several issues regarding the accuracy of the results which has been addressed in this paper, e.g., accuracy in simulation of crack path, extent and width of the damaged region, fracture resistance behaviour in situations such as symmetric vs. non-symmetric boundary-value problems, mixed-mode loading vs. mode-I loading of the crack-tip, etc.

Identify soil domains in the proposed alignment and their extent in width and depth along the alignment.

The objectives of the geotechnical characterization are: 1. Identify soil domains in the proposed alignment and their extent in width and depth along the alignment.

However, it is not clear whether the extents and face widths of colonnades are reasonably correlated, especially whether the face widths of the upper and lower colonnades from 850 to 1100 masl are consistent with the extent of the observed colonnades.

For the ponded drainage scenarios also, directional conductivities and thickness of a soil profile, extent of partial penetration and width of the ditch drains, levels of water head at the surface of the soil as well as on the ditches are observed to influence the travel times in a noticeable way.

The extent of cellulitis (length and width, lesion surface area) and presence of lymphadenopathy will be recorded on pre-determined time points (Table  1).

When assessing cell polarity, it is useful to define to what extent the width and length of the cell approximates to a circle (circularity).

DOI: http://dx.doi.org/10.7554/eLife.06394.008 10.7554/eLiFigure94.009 Figure 3 figure supplement 2. Little correlation between height of Hairy peaks or width of Hairy-bound region and extent of H4 deacetylation blocks and width ( A ) or height ( B ) of Hairy peaks.

The asperity rectangle of the synthesised distribution is specified as fractions of the fault length and width, whereas the extent of the slip concentration around the asperity is specified as a percentage of slip within the asperity rectangle with respect to the total sum of slip over the fault plane.

A boundary strip of 10% of the length and width of the extent of the population of points was used to remove the bias associated with sampling close to the edge of the study area.

These variables contrasted with the strongly negatively loading nares length, and to a lesser extent with bill width, outer rectrix length, and width of the claw of digit III.