Sentence examples for expected density of from inspiring English sources
where μ f is the expected density of dominant interferers, TX i, for the packet at RX0.
Using (58), we can now plot the expected density of successfully detecting nodes (p D ·λ(p D )) as a function of the required detection probability.
The number of sensor nodes are distributed according to the two dimensional Poisson point process with ρ as the expected density of nodes in a cluster A C. The cluster covers a circular region with its cluster head at the center o with radius R. It is presumed that there are total k clusters in the sensor network.
The concrete mixture consisted of cement CEM I 52.5 R (16.0 wt, limestone gravel 2/12 (43.8 wt, sand 0/2 (26.5 wt, water (6.7 wt, limestone filler (6.7 wt and a high-range water reducer (0.3 wt. The expected density of this mixture was equal to 2378 kg/m(^{3}).
The estimated terrain-resistivity ranges of the carbonate aquifer at this area are very important for classification of the expected density of fractures and in expecting the hydrogeological properties of the aquifer such as the porosity, hydraulic conductivity, groundwater potentiality and their quality, and so on.
Ultramafic bedrocks had a higher than expected density of rare plant locations.
Although all three primer sets yielded a single band on an agarose gel, only one set (gmnark) produced good quality TILLING gels as determined by adequate quantities of single stranded full-length PCR product and by the detection of a low number of cleaved bands likely to represent induced mutations based on expected densities of chemically induced mutations in plants.
The model allows the explicit computation of the expected density for each species (see Methods and Materials S1 for details).
This quantity is deterministic and predicts the expected density or concentration of a particle.
Plots with <60% of the expected density were excluded from the grain yield and moisture data sets.
As expected, the density of all samples increased with the sintering temperature (HPIM 6.81 g/cm3; TC—6.65 g/cm3 at 1300 °C).
