Sentence examples for excessive channel from inspiring English sources

Cross-layer mechanism is able to overcome many challenges for QOS due to excessive channel sharing.

This is compared with the channel occupancy rate without the use of CDUL and it is clear that when all the GWS are involved in the service, a large amount of service information broadcasting leads to excessive channel resource occupancy and, especially when the request for gateway service is less, channel resource waste is serious and not conducive to the rapid broadcast of other urgent messages.

One additional subject was removed due to excessive channel noise, reducing the total number of participants to 11.

OsGLR2.1 driven by 35S may have a more serious leaky effect, which results in the excessive ion channel activities and subsequently leads to the death of the transfected E. coli.

As mentioned in Section 2, using ABSs is standardized in 3GPP to protect victim UEs that are subject to excessive co-channel interference.

The use of almost blank subframes (ABSs) is standardized in 3GPP LTE Rel-10 as a part of the enhanced inter-cell interference coordination (eICIC) framework to protect UEs that are subject to excessive co-channel interference ([16] Ch. 31.2.2) [18,22-24].

Specifically, we seek succinct conditions that predict excessive dependence between channel access delay and system size.

Using BESA software, channels with excessive artifacts were spline interpolated (in average 3.5 channels per subject), and eye blinks were corrected (multiple source eye correction method [ 48], as applied in the Zurich study).

Excessive water in a channel is an important factor that triggers channelized debris flows.

The exposure of K+ channels located at the juxtaparanodes leads to excessive conductance of K+ channels so that the axolemma is held close to the equilibrium potential of K+.

However, since full CSI knowledge would require excessive use of the channel resources for exchange of CSI information through feedback from the users to the BS, in practice the BS only requests for SNR level information from the users, which is inadequate for optimal beamforming.