Sentence examples for example the thickness from inspiring English sources
In this example, the thickness ratio of the piezoelectric layer and main plate (h1/2h) is 1/10.
For example, the thickness of the film formed by the electrolysis for 2 h was ca. 2,000 Å.
In S rail example, the thickness distributions have been compared with experimental analysis after obtaining the optimum blank with Linear IFEM.
However, in shallow Quaternary aquifers, soil and hydrogeological conditions are not constant; for example, the thickness and foliation of soil layers vary in each aquifer, which cause differences in groundwater flow velocity, direction and percolation.
The properties of the lava flow and the setting of the building in the area were also recorded to give some context, for example the thickness and type of lava flow, and if the building walls were oblique or perpendicular to the flow direction and in-between or within the main flow channels.
For example, the thickness and cohesiveness of a marine-intertidal microbial mat (see Bauld 1981; Bauld et al. 1992) are greater than in a mature biological soil crust (Belnap and Lange 2001), thus the latter will be less prone to fossilization than the marine one.
The results can be seen in Fig. 2. A clear delay for the growth-mode transition can be found at the InAs/GaAs sample: for example, at the thickness 1.5 ML, the InAs/In0.15Ga0.85As structure had finished the sharp rise of intensity, whereas for the InAs/GaAs structure, the transition had not even started.
For example, because the thickness of each lamina varies greatly in areas for primate brains (e.g., see Fig. S3 of [23]), it will become difficult to construct layer maps using the same layer borders for different areas.
For example, the superconductor thickness used in HFGW detectors will be critical.
For this example, the domain thickness along the (Ox_{2}) axis is equal to t. Figure 1 Example of the domains (pmb{omega_{t}}).
For example, the crustal thickness of the Tibet plateau on the NW side and the Sichuan basin on the SE side of the Longmenshan fault are about 70 km and approximately 40 45 km, respectively, with the mean crustal P velocity of approximately 6.25 6.30 km/s and approximately 6.45 6.50 km/s, respectively (Teng et al., 2008).
