Sentence examples for evolution profile of from inspiring English sources
From principles of slow viscous flow, a third-order differential equation is derived which, when combined with the integrated form of the continuity equation, yields the time evolution profile of the film thickness.
The evolution profile of the energy partition shows the following tendency in all the three modes: the partition increases in the early evolution phase, reaches a maximum value (or peak of the energy partition), and becomes diminished in the late evolution phase.
Furthermore, the evolution profile of the gas phase saturation S g, the liquid phase pressure P L, and the total molar fraction of hydrogen X are plotted at different time (t=150,1×103,5×103,6×103 centuries) in Fig. 4 a −c, respectively.
The results demonstrate that the proposed model can predict the evolution profile of voltage across the supercapacitor more accurately than the ERE model, and therefore provides a better alternative for supporting research on storage system design and power management for wireless sensor networks.
However, additional data from gene expression profile, frequency of gene duplication and accelerated evolution profile of sea snakes is needed to further test this hypothesis.
The aim of this study was to define evolution profiles of body composition among human immunodeficiency virus (HIV -infected men witHIV -infectedhy.
With the best-fit rate constants of the reaction model, the species evolution profiles of 13M HAN were reasonably recovered, and the condensed-phase mass fractions were predicted.
It is not surprising that no single clinical rule has sufficient operating characteristics to be useful in this wide spectrum of evolution profiles.
Over the last two decades, experimental data of the nature of species evolution profiles and ignition delays from rapid compression machines (RCMs) has been used to develop and validate chemical kinetic mechanisms at low-to-intermediate temperatures and elevated pressures.
The film evolution profiles, obtained via numerical solution of the model equations, are used to calculate the ratio of film interfacial area to that of the substrate.
