Sentence examples for ethanol flushing from inspiring English sources

This study assessed the impact of ethanol flushing on the numbers and activity potentials of trichloroethylene (TCE -degrading microbial populaTCE -degradingin aquifer soils taken imicrobialy after and 2 years after ethanol flushing of a former dry cleaners site.

All samples were collected by Levine-Fricke-Recon, Inc. (Tallahassee, FL) from multilevel sampling locations at the Sages site, where ethanol flushing treatment was performed in August 1998.

Positive results in these experiments would justify simulating ethanol flushing in the laboratory as an alternative means of tracking population changes in the soil over time.

However, higher rates of methane depletion were observed in those microcosms with the 1- and 5-week column soils subjected to ethanol flushing.

Immediately after ethanol flushing, soil samples were removed from three monitoring well (MW) sites, designated as MW-8, MW-9, and MW-11, located approximately 51, 26, and 97 feet, respectively, from the closest recovery well.

With the positive identification of methanotrophic and sulfate-reducing bacteria in some of the soil samples, column studies were performed with Sages site soil to simulate ethanol flushing and assess effects on microbial populations present over time.

Stock solutions of TPP compounds were made up in absolute ethanol, flushed with argon and stored at –20 °C.

The eluate was evaporated under nitrogen; the residue was dissolved in 40 μL of ethanol, flushed with nitrogen, and stored at -80°C awaiting HPLC-MS/MS analysis.

The presence of residual ethanol after flushing did not affect sulfate-reducing activity (comparing all three 15-week column results).

The goal of this work was to determine if the introduction of the ethanol during flushing impacted the activities (and indirectly, their ability to transform residual contaminant) of the microorganisms present in the Sages site soil.

The printing system was sterilized with 70% ethanol and flushed with DI water before and after each ejection and constantly heated with a heating pad during ejection to avoid gelling of agarose.