Sentence examples for estimation coefficients from inspiring English sources

Step 4: Calculation of the statistical properties of model outputs: The model outputs are estimated followed by the estimation coefficients.

3Entries refer to estimation coefficients using the same modified dep.

Estimation coefficients (B) of PVT were calculated using decimiles for GluDiff and GluSD.

Table 7 presents estimation coefficients for the probability of a permanent layoff when controlling for firm shutdown selection effects for men while Table 8 provides estimation coefficients for women.

Then, the lattice joint process estimation coefficients are computed by means of: mathbf{Theta}_{ell_{k}}(n)={mathbf Xi}^{-1}_{ell}(n) {mathbf{Gamma}}_{ell,k}(n), (43).

Considering the estimation coefficients, the results of the model show that among all the different types of disasters, on average 55% of the time, flood related disasters have significantly impacted economic growth.

Comparing this distribution with the original estimation results before permutations (usually called the empirical estimation coefficient), the percentage of estimates greater or equal to (or smaller or equal to, in the case of negative coefficients) the empirical estimation coefficient in all estimates constitutes the QAP statistics.

17.357a 820.080a 18.9.957a.958.782a782a 5.719b Note: In DOLS (Pooled) and FMOLS (Pooled) estimation coefficient of covariance was computed using sandwich method and in DOLS (Grouped) estimation individual heteroscedasticity and autocorrelation consistent standard errors and covariances were used.

4.883b 25.938b 6.930a 9.140a 2.805ca 2.805c Note: In DOLS (Pooled) and FMOLS (Pooled) estimation coefficient of covariance was computed using sandwich method and in DOLS (Grouped) estimation individual heteroscedasticity and autocorrelation consistent standard errors and covariances were used.

The estimation coefficient was obtained by multiplying the reciprocal of the parameters mentioned in this table.

The estimation coefficient was found by multiplying the reciprocal of the parameters in the model.