Sentence examples for estimates so as from inspiring English sources
For all analyses, however, syntheses were achieved using a weighted linear combination of the study estimates so as to give more weight to studies of larger size.
The proposed algorithm applies an iterative approach initialized with approximate closed form estimates so as to guarantee stability and convergence.
Data obtained during stimulation and for 5 milliseconds afterwards was not buffered into the rolling entropy estimates so as to not taint the entropy estimates with stimulator artifact.
A weighting factor was used in the analysis to obtain prevalence estimates so as to reflect the likelihood of sampling each student and to reduce bias by compensating for differing patterns of non response.
The objective of this paper, therefore, is to calculate the differences in mean costs and effects of the interventions, and the precision of those estimates so as to inform sample size and other design considerations for a future definitive trial.
This model is run for each of the treatment groups using the intervention-specific costs, disease-free survival (DFS) estimates, age-specific population mortality rates and utility estimates, so as to calculate total costs, life years gained (LYG and QALYY outcomes for each treatment group.
First, in the so called mixing matrix estimation, the normalized columns (a i )1≤i≤N are estimated so as to obtain an estimate of A. Then, on the basis of this estimate, the second step called signal recovery, provides a solution to Equation (2).
Nevertheless, both employment creation and destruction effects of the policy are estimated so as to measure net employment growth.
The required neutron source strength at the target has been estimated so as to make the epithermal neutron flux in the patient irradiation field exceed 1.7 × 109 n/cm2s.
Now the values of (xe, ye) and te need to be estimated so as to obtain the information corresponding to the event.
In the course of designing, the composition of a large section of prehardened mold steel for plastics was estimated so as to lower the quantities of oxide inclusions to change the type of carbides and to raise the machinability.
