Sentence examples for estimated power density from inspiring English sources
The results showed that the difference of power production between the two Weibull curves was 9.23%, which was lower than the estimated power density deduction.
Total estimated power density on the rotating target is 11.5 kW/cm2 for the diameter and power of D+ beam are 10 mm and 9 kW (300 kV, 30 mA).
Figure 5 shows the current versus voltage (I-V) curves for the ZnO/ZnTe nanowire arrays measured both in the dark and under light illumination through a xenon arc lamp with an estimated power density of about 40 mW cm−2.
For comparison, estimated power density at a distance of 18 m from a 100 W incandescent light bulb is −2.22 dBm (0.6 mW/m).
Hocking et al. (1996) compared cancer incidence in three municipalities immediately surrounding three TV transmitters in northern Sydney, Australia, with the cancer incidence in six adjacent municipalities, estimating power densities from information on commencement of service of each transmitter, power, and frequency band.
Moreover, it is shown by simulations that the proposed sub-Nyquist rate non-uniform sampler is accurate enough to detect the edges of the estimated power spectral density.
The authors show that the proposed sub-Nyquist rate non-uniform sampler is accurate enough to detect the edges of the estimated power spectral density.
In this article, the estimated power spectrum density is analyzed and simulated using both nested sampling and coprime sampling structures, which provide us a new way to efficiently use the spectrum.
Thus, we utilized time-dependent Fourier transform also referred to as the short-time Fourier transform to estimate power spectral density (PSD) of RS by using DFT of finite-length segments of the RS, obtained by banks of rectangular filters such that, each filter has different duration.
Fast Fourier transformation was performed to estimate power spectral density.
We therefore measured power of the oscillations in the alpha and beta bands using the pmtm function in MATLAB for each channel and frequency band implementing the Thompson (1982) multitaper method for estimating power spectral density.
