Sentence examples for error may be used from inspiring English sources

The deduced transformation error may be used as guidance, in the absence of more-accurate site specific values, for determining overall geotechnical variability that is needed in reliability based analysis and design.

These findings also demonstrate how residual spatial error may be used as a diagnostic for comparing exposure model performance.

The minimal detectable change represents an estimate of the smallest amount of change that is not due to measurement error and may be used to determine if the individual performances were likely due to measurement error or a true change in maximal force output [ 26].

If the errors are assumed to be independent, R j  = σ2I, but correlated, the functional structure for the error terms may be used.

Several quadratic error criteria may be used.

Working in the general framework of the specialized implicit descriptor representation, it shows how a statistical quantization error model may be used in order to define stochastic sensitivity measures that are definitely pertinent and normalized.

Finally, an example is shown that the two presented methods can make the mode-truncated error reduce and may be used to approximate the influence of nonviscous modes contributed to FRF matrix due to the fact that the nonviscous modes are difficult to be obtained accurately even if a small scaled model is used for some eigensolution methods.

Factor five related to open disclosure of errors and hence may be used as a measure of students' willingness to openly disclose errors to patients, regardless of whether or not harm occurs.

That is, as seen in Figure 3, the sensor values are gathered into the microsymbol layer and the Bayesian network, based upon that representation, produces an snapshot symbol layer (error or not) that may be used in the upper layer, the representation symbol one, to call a reaction.

Clinically, the observed error suggests that the VTO may be used for demonstration and communication with a patient or consulting practitioner.

The model accurately reproduces experimental results (Normalised Root Mean Square Errors lower than 2.5%) and may be used in control systems as well as in adaptive stiffness systems.