Why should I have to take this pill?" Correction: September 6, 2000, Wednesday Because of a mechanical error, material was omitted from Page F2 in some copies of Science Times yesterday.
This unit also minimizes some other errors like common mode error, material error, etc. Theory of operation and design of the circuit has been explained in this paper.
First, variability of the compressive resistance of FRP-confined RC columns considering uncertainty in the model error, material properties, section dimensions, FRP strain efficiency factor and minimum load eccentricity as well as any existing correlation among random variables was studied.
The effect of probability distribution of model error, material strengths, live load type, structural safety class, live-to-dead ratio, reinforcement ratio, discretization of wall thickness, eccentricity and load effect combination were considered when calculating the structural reliability of reinforced grouted concrete block masonry walls in compression.
The experiments allow the evaluation of the error sources such as: stability, axial motion errors (residual errors), material dependence, tilt angle and roughness of the tested object.
A piping system may fail due to a variety of causes and damage mechanisms, including design errors, material failure, production, installation, service conditions, and environmental factors, such as mechanical loads, thermal effects, chemical agents, and ageing factors.
There is a lot of trial and error in materials development and use, which is exacerbated by the uncertainties about OLAE applications.
Common sources of error, calibration materials, and recommendations for the accurate measurement of optical properties at near normal and oblique incidence are identified in the chapter.
Additional manual review removed four variants owing to high probability of error (see Materials and Methods).
There exist multi-source errors in space deployable structures, such as dimensional error, imperfect material properties, and thermal error in space environment.
The mathematical models were developed to predict the results which are within the limits of agreeable average error for material removal rate and surface roughness through additivity test.
