Sentence examples for erosion limit from inspiring English sources
This parameter and the strain based erosion limit were subjected to calibration.
Moreover, using Masson, Wischmeier Smith's and recent erosion limit intervals gave a realistic spatial erosion distribution.
Under the right conditions, rapid rock uplift and efficient glacial erosion limit topography, induce steady-state orogenic flux, and focus crustal strain, thus imparting geodynamic significance to glacial climate.
The total area that experienced soil erosion rate above the maximum tolerable erosion limit of 11 t ha−1 yeaRenardetald et al. 1996) is 5440 ha, which covers 21.25% of the entire watershed.
The glacial buzzsaw hypothesis suggests that efficient erosion limits topographic elevations in extensively glaciated orogens.
Slurry erosion limits the useful life of equipment and is therefore a critical parameter for design, selection and operation of the hydraulic transportation system.
Finally, although tried in some locations, regulating soil erosion limits is not a common approach (Libby, 1985).
The slides were graded as: 0, normal, no damage; 1, minimal synovitis, cartilage loss, and bone erosion limited to discrete foci; 2, synovitis and erosion present, but normal joint architecture intact; and 3, extensive erosion and joint architecture disrupted.
Each stained section was scored by a blinded observer for changes in the joint architecture using our previously described grading system [ 20, 24] as follows: 0 = normal, 1 = minimal synovitis and bone erosion limited to discrete foci, 2 = extensive synovial hyperplasia and some destruction of segments cartilage and bone and 3 = complete destruction of the joint architecture.
The histological severity of arthritis was graded as follows: 0 = normal; 1 = minimal synovitis, cartilage loss, and bone erosions limited to discrete foci; 2 = synovitis and erosions present but normal joint architecture intact; and 3 = synovitis and extensive erosions present and joint architecture disrupted.
However, low toughness and erosion resistance limit the suitability of electroless Ni-P coatings as pipeline coatings.
