Sentence examples for equilibrium loading from inspiring English sources

The adsorptive behaviour under various process conditions was evaluated using equilibrium loading isotherms.

It was observed that the equilibrium loading of fines in the adsorbents was independent of their concentration in the slurry.

At low pressures, the equilibrium loading increases as the porosity decreases, whereas at high pressures it increases with increasing porosity.

The usefulness of the model in the design of loading experiments for desired drug loading efficiency and equilibrium loading was demonstrated by numerical analysis.

The maximum binding capacity of the micrsophere and the association rate constant had positive effects on the loading rate and the equilibrium loading.

For both the ions, the equilibrium loading (∼3 15 mg/g) in the adsorbate were found to be comparable to the adsorbates reported in literature.

Size dependent release behavior was quantified by diffusion studies with equilibrium loaded SELP hydrogels.

Peak and equilibrium loads were analyzed to determine strain amplitude and strain rate dependence of linear versus nonlinear responses.

Direct loading diffusion studies confirmed that hydrogels produced by direct incorporation of cytochrome c with the aqueous SELP solution did not significantly influence the release behavior compared to equilibrium loaded hydrogels.

In particular, the purging processes leading to reduced inbreeding or drift load may be demographically costly, which implies that some metapopulations will have a low demo-genetic viability despite a small expected equilibrium load.

Without removal of this equilibrium load (Neq) samples were then left opposed under Neq for pre-sliding durations (Tps) of 1200, 120, 12, and 1.2 s, and rotated +2 revolutions and −2 revolutions at 0.3 mm/s after each Tps.