Sentence examples for enough for measurement from inspiring English sources

Though ELISA is a common method to measure cytokine levels, it appears that it is not sensitive enough for measurement of IL-23 in serum.

The experiment at 10 GPa, 1500°C (G#3) resulted in coarse opx + SiC plus three iron silicides (FeSi, FeSi2, and FeSi4) and olivine that did not develop equilibrium rims large enough for measurement.

Consistent with what was observed in the bound protein, few of the amides in AR3 helix 2 exchanged slowly enough for measurement of protection factors even though the cross-peaks were clearly visible in the HSQC spectrum.

Because some samples did not have enough serum for measurement, estradiol concentrations were available from 359 male patients and 378 male controls.

Unfortunately, the film cast from the solutions of OTZnS was very brittle and not self-standing enough for the measurement of refractive index.

This blank value obtained is enough for the measurement of most environmental samples and comparable with other reported backgrounds obtained in facilities working at higher energies and higher charge states.

The research objectives formulated generally in university statutes are fundamental with respect to the interests of various stakeholders; however, they are not specific and manageable enough for performance measurement.

A microphone (Sennheiser KE4 211-2) with an attached silicone tube was placed 2 mm in front of the eardrum, close enough for precise measurement, but without running the risk of damaging the eardrum [5].

This time point was chosen, as it defined the narrow time window when the tumor size in both cohorts was sufficiently small for DOX infiltration, but large enough for accurate measurement.

After a minimum of 2 months baseline adherence monitoring period (long enough for any measurement effect on adherence to dissipate) [ 18, 32], only the patients with suboptimal adherence during baseline are randomised.

The validated range of Tono-Pen XL measurements has an upper limit that is not big enough for IOP measurements during suction ring application.