Sentence examples for end of the injection from inspiring English sources

Values of pH increased but did not achieve 6.2, the pH of the injectate, by the end of the injection.

A pneumatic injection nozzle was also fabricated, tested and fitted to the end of the injection conveyor for direct injection and dispersal into the fluidized bed.

Under short ignition delay conditions, the experimental results for the Ar O2 atmosphere indicated a lower heat-release rate, which continued to the end of the injection and resulted in a longer combustion period, whereas the heat-release rate under the air (N2 O2) atmosphere terminated simultaneously with the end of the injection.

Typical colloid breakthrough curves show two important behaviors: a constant outlet concentration value after a transient phase, and a pronounced tailing effect at the end of the injection step.

After reaching a maximum of 0.07 μM, As concentrations decreased through the end of the injection.

For hand injection, the scan starts at the end of the injection.

The injection end of the thick injection and thin production type well group easily forms a high-permeability zone, which makes it difficult to improve the injection pressure of the reservoir; therefore, the low-permeability reservoirs are difficult to produce.

As Figure 4A had demonstrated, after injection of PAMNPs with the maximum dose (138 mM, which is 100 times higher than working concentration), the surface of skin tissues on the dosing side of the rabbit ear is covered with squamous epithelium for both near-end and far-end of the injection site.

This concept enables pressure distribution during fluid injection over two separated ends of the injection well, thus minimizing the risk of induced seismicity.

Under the condition of equivalent injection rate for every well group, the end of injection of the thin injection and thick production well group needed relatively higher injection pressure compared to thick injection and thin production.

The medium AHP (mAHP) was measured as the peak hyperpolarization immediately after the offset of the depolarizing current injection, the slow AHP (sAHP) was measured 800 ms after the end of the current injection.