Sentence examples for elution testing from inspiring English sources

Five were used for surface and total porosity measurement and five for elution testing.

Elution testing was conducted to estimate the amount of gentamicin released into the pin tract.

Elution testing revealed that the gentamicin coated polyurethane sleeves released significant quantities of the antibiotic for up to 26 weeks.

Elution testing with 0.50 M HCl 0.50 M thiourea solution for both Pd and Pt achieved an elution rate of above 93% and showed no significant decrease after five adsorption desorption cycles, indicating that PAN TU GA may be regenerated and reused.

Water elution test was replicated twice.

The elution test was carried out at a specific S/L ratio and at varying time (from 5to9090 min) to determine the effect of elution time.

Elution tests in laboratory-scale columns suggested that virtually all the impurities can be separated from the iron chloride solution by anion exchange.

The study used: gas chromatography mass spectrometry (GC MS) tests, 1H Nuclear Magnetic Resonance NMRR) tests, X-ray fluorescence analysis, emission spectral analysis (ICP), elution tests in anion type surfactant solution conducted for mortar and aggregate taken from the cement concrete where pop-out had occurred, as well as samples made by cement paste in the laboratory.

The primary focus of the work presented herein is the analysis of induced-gradient contaminant elution tests conducted in a source zone at the site, investigation of the potential occurrence of immiscible liquid in the saturated zone, characterization of the relationship between mass flux reduction and mass removal, and evaluation of the impact of source-zone management on site remediation.

The stabilized specimens were then shipped at ambient temperatures from Iquitos to Lima, Peru, where they were held for an additional 5 8 days before elution and testing.

However, 3 weeks is the maximum elution period tested in this project, and it does not mean that higher elution times will not decrease hardness, but with regard to the data exhibited in the study, the length of time the load-bearing PMMA bone cement is allowed to stay within the patient before the second surgery of two-stage revision arthroplasty is not detrimental to its structural integrity.