Sentence examples for electron multiplying from inspiring English sources

Imaging of the atoms is performed by two near-orthogonal electron multiplying charge coupled device (EMCCD) cameras using a 25 ms exposure time to observe 423 nm fluorescence.

To optimize this ratio in practice, we used the multi-pixel sensor of an electron multiplying charge-coupled device (EMCCD) camera as our idler detector (Fig. 1a).

Ion currents of a few specially positioned ion pumps were slight high in the high beam current, which can be explained as an effect of electron multiplying.

However when the brightness of the observed target changes in large ranges in a few minutes, a fixed electron multiplying (EM) gain may not be optimum.

RMD is developing a cost effective detector for time-resolved small angle X-ray scattering (SAXS), using a cooled, 512×512 pixel electron multiplying CCD (EMCCD).

After the atoms are initially loaded at the sites, the first computer checks the occupancy of each site by reading out the electron multiplying charge-coupled device (CCD) images.

The super-resolution imaging set up captures images through the microscope onto an EM-CCD (electron-multiplying charge-coupled device), a specialized scientific camera.

We used macro zoom microscopy (MVX10, Olympus) with 1× objective lens (Olympus MVPLAPO1X, numerical aperture 0.25) on a cooled electron-multiplying charge-coupled device (EM-CCD) camera (iXon DU-897E-BV, Andor Technology).

Light emission from the samples was focused by a 40× oil-immersion objective lens (Nikon Plan Fluor, numerical aperture 1.3) on a cooled electron-multiplying charge-coupled device (EM-CCD) camera (ImagEM; Hamamatsu Photonics).

Fluorescence emission from the sample chamber was projected through a transmission grating onto a cooled electron-multiplying charge-coupled device.

The fluorescence was collected using an Andor electron-multiplying CCD-camera (iXon 897-D) and measurement software written in LabView.