Sentence examples for electrode set up from inspiring English sources

Highly orientated pyrolytic graphite (HOPG) offers greater advantages in terms of the exfoliate size but the source electrode set up introduces difficulties to the procedure and requires the use of sonication.

After the EMG electrode set up was complete, the subject was asked to perform a double leg raise exercise, which would be used for normalization of the data.

EC measurements were carried out using an Autolab potentiostat system in a three-electrode set up using Pt wire and reversible hydrogen electrode (RHE) as the counter and reference electrode, respectively.

Six individually monitored electrodes set up in the same reactor showed very good reproducibility, indicating that discrepancies observed between the different experiments were mainly due the different batches of compost.

Case and Control hiPSC-RPE were cultured on ECIS medusa arrays (Applied Biophysics, NY, USA) incorporating a 2-electrode set up: working and counter electrodes.

For the Main Pyramid, the electrodes were set up around the perimeter of the structure, since they were not permitted to be inserted over the edifice, thus preventing damages to the architectonic elements.

Their capacitive behaviour was studied by cyclic voltammetry, galvanostatic charge-discharge and electrochemical impedance spectroscopy in two different alkaline electrolytes using a three electrode set-up.

The left DLPFC was stimulated in a pre-post design using a new electrode set-up (a 9 cm2 electrode was placed over the left DLPFC while a 35 cm2 was placed over the parieto-occipital cortex) contrasting anodal versus cathodal stimulation.

It is based on a syringe type die-counter electrode set-up used for conventional continuous electrospinning, the key feature being a reduction of the distance between the spinning die and the substrate from the conventional value of 10 50 cm down to the millimeter and below mm range in order to suppress the onset of bending instabilities and the corresponding spread of the deposition area.

Electrochemical experiments were performed in a two-compartment electrochemical cell using a three electrode set-up, with a Pt wire counter electrode and a KCl-saturated Ag/AgCl reference electrode.

We set up electrodes around the borehole and observed self-potential variations to investigate the magnitude of electrokinetic and hydraulic parameters around the Nojima fault zone.