Sentence examples for electrode pillar from inspiring English sources

The studies showed that the polarization in the electrolyte can be decreased by increasing the electrode pillar length, while increasing electrode distances led to a nonuniformity of the electrochemical activity.

Modeling results demonstrate that ultra-thick LiCoO2 electrodes, on the order of 150 300 μm, can garner a substantial improvement in material utilization and in turn capacity through electrolyte channels and fine width electrode pillars which are 25 100 μm wide.

The height of the electrode pillars and the distance between them were systematically varied in the simulations to evaluate the effects on ionic transport in terms of concentration, concentration gradient and the minimum concentration in the electrolyte.

The interlocked interface formed between the nano-pillar Ni electrode and nano-pillar PDMS composite thin film effectively enhanced the triboelectricity of a triboelectric nanogenerator (TENG) by increasing the surface contact area and contact time, related to the frictional forces.

In such device, typically any gain due to electric field enhancement close to the pillar electrode is quenched by the reduction in the electric field close to the outershell electrode.

Glial proliferation was observed at the base of the pillar electrode arrays and inside the chambers.

This results in a 3-dimensional focusing effect, where the incoming flow stream (from an off-chip injector) is focused onto the pillar detection electrode.

The electrode covering the micro-pillars is patterned to decrease the capacitance, and hence increase the sensitivity of the sensor.

The detection limits are improved with the deposition of metals onto the embedded electrodes to create pillars, increasing the surface area of the electrodes.

Between the two metal electrodes a drop of electrolyte solution is suspended over the pillar surface with a gate silver electrode on the top.

MEMS inertia switch consisting of three main parts: the proof mass suspended by the folded springs as the movable electrode, the upper beam and back pillars as a barrier system and the forward novel L-shaped elastic cantilever beams as the fixed electrode.