Sentence examples for electrical load is from inspiring English sources
For the remaining hours where electrical load is relatively high, the gas-fired unit is operated to generate electricity and maintain power system security by providing up/down ramping capabilities to handle worst cases.
When an electrical load is attached to these terminals, current will flow through the load.
In most cases, they operate as variable resistances; that is, resistance decreases when the electrical load is heavy and increases when the load is lighter.
If no electrical load is connected to the generator, the applied heat source power results in a temperature differential (ΔT) with a value dictated only by the thermal conductivity of the p- and n-type semiconductor legs and their dimensions.
It can be seen that at hours 5 6, electrical load is low and wind generation is high, whereas electrical load is high and wind generation is low during load peak hours 16 20.
The thermoelectric power production relative to an increasing electrical load is investigated by means of an analysis of experimentally measured results in which the thermal input conditions are varied.
Its electrical load was 10,188 megawatts this afternoon, much lower than its record peak load of 11,850 megawatts in July 1999.
The average electrical load was approximately 9 % of full load.
Additionally the model is targeting a national electrical load be spread-out evenly throughout the year in order to satisfy best economic performance for electricity generation, transmission and distribution.
In Fig. 8, Γ c and Γ h are fixed at 1 and 1, respectively, to ensure the worst-case cooling and thermal load; the uncertainty set of the net electrical load are enlarged by increasing the robustness Γ nl from 0 to 2. Table 10 shows the change of operating cost as the robustness budget Γ nl increase.
The fracture problem of a penny shaped crack in a piezoelectric ceramic cylinder surrounded by an infinite elastic medium under in-plane normal mechanical and electrical loads is considered with the electric continuous boundary conditions on the crack surface.
