Sentence examples for electrical data is from inspiring English sources

A table of the electrical data is shown in Table 2, for each time input, there are corresponding values for each of the four sensors (labelled Sensor 1...Sensor 4) and the physical location of the sensor (labelled Sensor 1 Location...Sensor 4 Location).

The oldest electrical data are publicly available for 2002; hence, we used this dataset.

The electrical data were recorded by a Keithley 2612 source meter.

All the electrical data were measured by devices with the area of 250 μm × 250 μm.

The high pressure electrical data were only obtained for water contents less than 8 wt%.

The sheet resistance and other electrical data were measured by four-probe meter (KDY-1), Hall effect measurement system (Lakeshore 7704A), and LCR meter (Agilent U1731B).

For these traces a +200 mV bias was applied, optical data was collected at 4.8 kHz and down-sampled to 1 kHz, while electrical data was collected at 20 kHz and low pass filtered to 10 kHz.

Finally, a comparison of the simulation results with electrical measurement data is presented, which shows fairly good agreement.

Figure 4 e shows histograms for the log of the dwell time values observed in electrical measurements; data is presented for applied biases of 250 and 200 mV.

Mechanical, thermal, frictional, and electrical property data are provided.

Electrical resistivity data are in agreement with this interpretation.