Sentence examples for electric power efficiency from inspiring English sources

The prudent selection of anode material also impacts the required terminal potential for a given current density, and consequently the cell's electric power efficiency.

The design of the linac was based on using alternating-phase-focus (APF) and interdigital-H (IH) structures which give sufficient electric power efficiency.

A detailed comparison between the solarized and the conventional gas turbine is reported, taking into account GT electric power, efficiency and shaft speed.

For instance, the composite film with 10.0 wt% MWCNT exhibited low temperature growth/decay time constant of ∼1 s, stable maximum temperatures of 40 220 °C, and high electric power efficiency of ∼7.32 mW/°C under the relatively low applied voltages of 5 25 V.

The cell exhibits promising photocurrent density up to 11.7 mA cm−2, and the photo-to-electric power efficiency of 5.22%, for cell area of 0.24 cm2, under 100 mW cm−2 halogen light source.

The results show that at a water flow of 20 L/min and a power generation of 9 kW, the total efficiency (thermal efficiency plus electric power generation efficiency) of this system reaches a maximum 94.4% which is approximately 15 20% higher than that of the typical diesel engine exhaust heat recovery system.

So far, the output electric power and efficiency are the highest values for such a thermoacoustic electrical generator.

Initial results on a prototype show a light to electric power conversion efficiency of 2.8%, demonstrating the feasibility of the new tube concept.

An intermediate loop with molten salt as the working fluid transports power to a Rankine steam cycle; the estimated gross electric power conversion efficiency is 45% for the MEP and 47% for the FCP.

It seems the word "hybrid" has evolved into two meanings -- one that describes a powertrain using both internal combustion and electric power for more efficiency, and the other a more general term referring to a car perceived as earth-friendly.

Electric power and electric efficiency are increased by 2.353%.