Sentence examples for electric field levels from inspiring English sources
The patterns refer to electric field levels and were measured in an anechoic chamber.
They must verify key performance indicators such as minimal electric field levels in the tunnels, targeted bit error rates (BER), targeted handover times, etc.
The depicted electrical behavior of the conductive nanocomposite is thus clearly governed by the applied voltage in a nonohmic manner, which, as mentioned above, matches the expectation for a conductive nanocomposite at higher electric field levels.
As expected, a critical volume fraction indicated by a sharp increase in nanocomposite conductivity, i.e., the percolation threshold, can be inferred from the graph.In the following, electric current densities passing through the nanocomposite RVE were computed for different electric field levels and filler volume fractions.
We must remember that the approach used in [11] is different from ours, because it considers a ray-tube tracing method, reflection on curved surfaces is also considered. Figure 6 highlights some similar results for the tunnel C. Deep fadings are located in the same areas and Electric Field levels are globally similar along the tunnel axis.
This absence of correlation means that selecting on magnetic field levels implies negligible selection on electric field levels.
As the container fills, the zero electric field level moves upwards and the negative electric field disappears leaving the entire surface with a positive electric field.
The conditions of the PEF treatment were: electric field level of 8 11 kV/cm, 3 pulses, 50 μF capacitance or 12.5 kV/cm, 40 pulses, 1 μF capacitance.
This study presents nine modeling techniques within data mining process for the prediction of electric field level which depends on the positions of stirrer in the mode stirred reverberation chamber.
In practical situations in terms of crack length, applied load and electric field level, the retardation of crack growth is negligible when the dielectric constant of the crack interior is higher than 20.
The first stage from 4 25 untilto 8 27 UT was characterized by an increase of the electric field level up to 50 V/m.
