Sentence examples for elastic section from inspiring English sources

Suppose the straight-line equation in elastic section and in elastic-plastic section is ye = Dex and yep = Depx+D0 respectively, using least square method, De can be regressed as 6722, Dep as 2472, and D0 as 162.9.

This was done to obtain a better behavior of the beam column joint by having a linear elastic section with the beam or column elastic stiffness (Priestley et al. 2007).

It is further shown that the errors result from the narrow energy domain of the neutron elastic cross section spectral distributions and that an extremely fine energy grid is required to resolve the problem under the current formulation.

Cut off the elastic waist section.

Good agreement between the three methods was observed except for the sodium total and elastic cross-section and the uranium-235 total cross-section sensitivity coefficients where the multi-group adjoint method produced results approximately 14%and7%7% lower than the IFP and CLUTCH methods, respectively.

The method extends the "hole in the web" approach used by AS 2327.1 and the European Standard Eurocode 4 for the plastic cross-section analysis of non-compact webs (EC4 Class 3) to cover the elastic cross-section analysis of slender webs (EC4 Class 4).

The elsepa code also implements approximate factorization methods that allow the fast calculation of elastic cross sections for much higher energies.

In order to visualize collagen and elastic fibers, sections were counter stained with aqueous solutions of 5% tannic acid followed by 1% uranyl acetate, and then counterstained with lead citrate.

In Section Elastic net regression, we introduce the elastic net approach and we present the results of a leave-one-out cross validation for predictions on single and pairs of drugs.

The implications of these results are discussed in the contexts of critical feature spacing and the impact of incorporating low elastic-modulus sections (such as polymer dielectrics) on thermo-mechanical reliability.

The bracing elements may be plates or longitudinal stiffeners which should be designed to remain elastic while the section undergoes plastic deformation.